TCP listen port blocked, UDP is open How do I unblock this port?

BitComet BitComet General Discussion
1

Hello, list first: BitComet 1.28 - ATT DSL - 1 modem Westell Proline - 1 wireless router Trendnet / TEW-631BRP - Windows XP Professional - AVG anti-virus. I read through the guide. UPnP did get rid of the yellow light on the bottom of BitComet GUI so I turned off the UPnP function and did manual port forwarding. Also, the UDP & TCP listen port are the same port 51949. I have checked the router UPnP is still on. windows firewall have BitComet allowences. Windows also seems to be set right. I do have my up & down speeds set correctly. I went from both TCP AND UDP blocked to UPD open and TCP still blocked. I am not sure what to look at now. Anyone have any thoughts on what to try next?

Overall Tasks: Total: 25 / Running: 2

TCP Connections: Established: 6 [MAX:Unlimited] / Half-Open: 9 [MAX:10]

LAN IP: 192.168.10.200

WAN IP:

Listen Port of TCP: 51949 (Blocked by Firewall/Router)

Listen Port of UDP: 51949 (Opened in Firewall/Router)

Windows Firewall: Added [TCP opened, UDP opened]

UPnP NAT port mapping: Disabled

Overall Download Rate: 102 kB/s [MAX:Unlimited] Max Connection Limits: 50 per task

Overall Upload Rate: 3 kB/s [MAX:Unlimited] LT Seeding: 0 kB/s [MAX:Unlimited] All BT Upload Slots: 1

Memory Usage: Working Set: 30.84 MB, Commit Size: 26.25 MB

Free Memory: Phys: 391.52 MB (Min to keep: 50 MB), Pagefile: 2.37 GB, Virtual: 1.87 GB

Disk Cache Size: 13 MB (Min: 6 MB, Max: 50 MB)

Disk Read Statistics: Request: 924 (freq: 0.4/s), Actual Disk Read: 73 (freq: 0.0/s), Hit Ratio: 92.0%

Disk Write Statistics: Request: 9862 (freq: 5.5/s), Actual Disk Write: 615 (freq: 0.3/s), Hit Ratio: 93.7%

2

This sounds like your manual portforwarding setting is incorrect. On some router you can make a single rule for both tcp and udp, but some require a separate rule for each. Check your rule to make sure the protocol selected is both udp an tcp, or if necessary, make one rule for each.

3

Thanks for the quick reply.

Just checked it and my router sets port forwarding for both at the same time.

4

If possible, bypass your router and connect direct to your modem. If the problem clears, then you’ll know it’s in the router, otherwise it must be a firewall.

5

Thank you very much for you insight. I went directly into my modem and turns out it’s a strange single connection modem/router type from ATT. So I configured my router to handle the PPPoe negotiations instead and that bypassed the “router” portion of my modem. My modem didn’t have a port forwarding option, so this goes around it. I would never have figured this out until you mentioned it.

To others with same problem, check your modem to make sure it’s not a modem/router combo.

All green now!

Thank You Guardian Eagle!

6

Glad to help. We do have a guide on wiki.bitcomet.com for setting up multiple routers in a case like this, but since you were able to bypass your first router, it’s not an issue and all is well.